Panasonic CS-S12MB4ZW, Руководство по эксплуатации

Страница: 7 / 24

ENGLISH
7
NOTES NOTES
QUIET
,
POWERFUL
• Can be activated in all modes and can be cancelled
by pressing the respective button again.
• Cannot be selected at the same time.
TO SET THE TIMER TO SET THE TIMER
• To turn ON or OFF the unit at a preset time.
ON
OFF
1 2
TIMER
SET
Select ON or
OFF timer
Set the time Con fi rm
• To cancel ON or OFF timer, press
ON
or
OFF
then press
CANCEL
.
• When ON Timer is set, the unit may start earlier (up
to 15 minutes) before the actual set time in order to
achieve the desired temperature on time.
• Timer operation is based on the clock set in the
remote control and repeats daily once set. For clock
setting, please refer to Remote Control Preparation
at back cover.
• If timer is cancelled manually or due to power failure,
you can restore the previous setting (once power is
resumed) by pressing
SET
.
The unit stops and the timer indicator blinks.
Use remote control to retrieve error code.
CANCEL
TIMER
ON
1 2 3
OFF
CLOCK RESET
SET
CHECK
1
Press for 5
seconds.
3
Press for 5
seconds to
quit checking.
2
Press until you hear
beep sound, then write
down the error code.
Note:
• For certain errors, you
may restart the unit for
limited operation with 4
beeps during operation
starts.
4
Turn the unit off and reveal the error code to authorized dealer.
4
TO SELECT FAN SPEED (5 OPTIONS)
FAN SPEED
• For AUTO, the indoor fan speed is automatically adjusted
according to the operation mode.
5
TO ADJUST AIRFLOW
DIRECTION
AIR SWING
AIR SWING –
AUTO
• The vertical air fl ow louver swings up and down
automatically.
AIR SWING –
MANUAL
• The air fl ow direction can be adjusted as desired by using
remote control.
• Do not adjust the vertical air fl ow direction louvers by
hand.
• The air is discharge evenly through 4 output vents.
6
TO REACH
TEMPERATURE QUICKLY
POWERFUL
• This operation will stop automatically after 20 minutes.
7
TO ENJOY QUIET
OPERATION
QUIET
• This operation reduces air fl ow noise.
8 Press to restore the remote control’s default setting.