7-18
■
Line Processing of Antenna Cable
<Screw tightening order>
Ԙ
→
ԙ
→
Ԛ
→
ԛ
→
Ԝ
→
ԝ
Details of "A"
Details of "B"
<Screw tightening torque>
0.2 ± 0.02N·m(
ѳ
2.0 ± 0.2kgf·cm)
Avoid overlapping of
the Cable at right and
left of the claw as below.
Note: When processing the Cable, avoid any stress
on the soldered part of the PCB.
Ensure the Cable does not run over the rib,
boss and pin.
Hook each Cable
on the claws.
WLAN/
WIMAX AUX
Antenna
WWAN Main
Antenna
Screw(N1)
ԛ
Screw(N1)
ԝ
Screw(N1)
Ԝ
LCD Cable Cushion
LCD Cable Cushion
WLAN/
WIMAX AUX
Antenna
WWAN Main
Antenna
Screw(N1)
Ԙ
Screw(N1)
Ԛ
Screw(N1)
ԙ
Hook each Cable
on the claws.
Insert between the ribs.
Overlapping cable wiring.
(See figure right)
Becomes difficult to insert a Pen
A
B
Avoid running over the rib,
boss and pin to avoid
catching the Cable when
LCD Rear is set.
Avoid running over
Avoid running over
the rib, boss and
the rib, boss and
pin to avoid
pin to avoid
catching the Cable
catching the Cable
when LCD Rear is set.
when LCD Rear is set.
Avoid running over
the rib, boss and
pin to avoid
catching the Cable
when LCD Rear is set.
Power Switch
Power Switch
Cable Sheet
Cable Sheet
Power Switch
Cable Sheet
Power Switch
Power Switch
Cable Sheet
Cable Sheet
Power Switch
Cable Sheet
Wrap around the ANT
Wrap around the ANT
Cable and insert between
Cable and insert between
the ribs.When wrapping
the ribs.When wrapping
one by one, wrap as
one by one, wrap as
shown below.
shown below.
Wrap around the ANT
Cable and insert between
the ribs.When wrapping
one by one, wrap as
shown below.
The cushion must
come with in ±2mm
from the center of the rib.
How to wrap
Power Switch
Cable Sheet
How to wrap
LCD Cable Cushion
5mm
5mm
5mm
1) Attach the Cushion
to the black Cable as
shown.
2) Fold back the Cushion
on the left side of the Cable
and attach as wrapping
the Cable.
Apply pressure on the attached part.
3) Place the green
Cable on the attached
part.
4) Fold back the Cushion
on the right side of the
Cable and wrap 2 Cables.
5) Wrapping complete.
15±3mm
15±3mm
15±3mm
The green Cable
comes on top.
Insert into the Front rib after wrapping.
Insert into the Front rib after wrapping.
OK
NG
Cable
Cable
Pen Holder
Pen Holder
LCD Front
LCD Front
(MG)
Safety work
Safety work
Safety work
Safety work
S2
S2
S2
S2
S1:
⛘✼
S2:
✢ིߺ
S3:
ࠪࡖࡊࠛ࠶ࠫ
S4:
ຠ⇟⏕
S5:
ߘߩઁ
S1:Insulation S2:Pinching Cables
S3:Sharp Edge S4:Check Parts NO. S5:Others
ోᬺ
CAUTION
