![background image](http://html1.mh-extra.com/html/panasonic/aw-ue70wp/aw-ue70wp_operating-instructions-manual_3933051088.webp)
88
Web screen configurations
(continued)
OIS
Set the optical image stabilization function.
Setting value:
Off
Image stabilization function not used.
Mode1
Image stabilization function used (optical, 2-axis
compensation)
Mode2
Image stabilization function used
(electronic, 4-axis compensation)
Factory settings:
Off
●
“Mode2” cannot be selected when HDR is “Low” or
“High”.
●
“Mode2” cannot be selected when the Priority Mode
(page 46, page 67) is “IP(4K)”, “SD card(4K)”,
“USB(4K)”, or “HDMI(4K)”.
●
When “Mode2” is selected, the view angle
changes to set aside image pixels for use during
compensation.
●
When “Mode2” is selected, display of the output
image is delayed compared to the actual image.
●
Although the image stabilization of “Mode2” (hybrid
of optical and electronic compensation) produces
stronger compensation than “Mode1”, depending
on the shooting conditions, it may not be able to
differentiate between movement of the subject and
movement of the unit as it performs compensation
(electronic) on movement detected in the video
signal. Therefore, erroneous compensation may
occur.
●
The image stabilization setting cannot be changed
while data is being written to the SD card.
Notes
Speed With Zoom POS.
“Off” or “On” is set here for the function used to adjust the
camera direction’s adjustment speed in conjunction with
the zoom magnification.
When “On” is set, the panning and tilting operations will
become slower in the zoom status.
This function has no effect during preset operations.
Factory settings:
On
Focus Mode
“Auto” or “Manual” is set here for the focusing function.
Setting value:
Auto
The subjects are always brought into focus
automatically.
Manual
The focus is operated manually.
Factory settings:
Auto
Focus ADJ With PTZ.
“Off” or “On” is set here for the function which
compensates for out-of-focusing when it occurs during
panning, tilting or zooming operations at the manual focus
setting.
This item can be selected only when “Manual” has been
selected as the “Focus Mode” setting.
Factory settings:
Off
Tally
“Enable” or “Disable” is set here for the function which
turns on or turns off the tally lamp using the tally control
signal.
Setting value:
Disable, Enable
Factory settings:
Enable
IR Control
“Enable” or “Disable” is set here for operations conducted
from the wireless remote control.
The operations are enabled when the unit’s power is
turned on from an external device other than a wireless
remote control, and they are disabled when the power is
turned on from a wireless remote control.
Setting value:
Disable, Enable
Factory settings:
Enable
●
At the point when this item’s setting is changed, the
new setting is not reflected in operation.
It is reflected when the unit is set to standby mode
and its power is turned on.
●
Follow one of the procedures below if the item’s
setting is changed by mistake and the unit can no
longer be operated from a wireless remote control.
When menu operations can be performed using
another control device:
First change the item using a control device
capable of performing menu operations, and then
turn off the unit’s power and turn it back on.
When menu operations cannot be performed
using other control devices:
1. Turn off the power of the units and devices that
are connected.
2. Disconnect the unit’s AC adaptor cable and
LAN cable, and plug them back in.
3. Perform the operation for turning on the unit’s
power from the wireless remote control.
4. After changing this item, turn off the unit’s
power and turn it back on.
Notes
Содержание AW-UE70WP
Страница 143: ...143 Memo ...
Страница 144: ...Web Site http www panasonic com Panasonic Corporation 2015 ...