![background image](http://html1.mh-extra.com/html/panasonic/aw-ue20wp/aw-ue20wp_operating-instructions-manual_3718408077.webp)
77
This unit can be operated by remote control using a wireless remote control (model number:
AW-RM50AG) purchased separately. Check out the following points before using the wireless remote
control.
Point the wireless remote control at the unit’s wireless remote control signal light
‑
sensing
area (front side and back side), and operate it within a range of 10 meters (32.8 ft.) from the
area.
Refer to <Layout of wireless remote control signal light-sensing areas> on the below.
The signal sensing distance is reduced if the angle at which the wireless remote control
signals are sensed is increased.
The light-sensing sensitivity is reduced to about one-half when the wireless remote control is
pointed at an angle of 40 degrees from each position in front of a wireless remote control signal
light-sensing area (front panel or back panel).
If the unit is installed near fluorescent lights, plasma monitors or other such products or if
the unit is exposed to sunlight, the effects of the light may make it impossible for the unit to
be operated using the wireless remote control.
Be sure to follow the steps below for installation and use.
Take steps to ensure that the wireless remote control signal light- sensing area will not be
exposed to the light from fluorescent lights, plasma monitors or other such products or from
the sun.
Install the unit away from fluorescent lights, plasma monitors and other such products.
For about 10 minutes even after the batteries have been removed from the wireless remote
control, the selection of the operation to be performed (the CAMERA <1>, <2>, <3> or <4>
button which was pressed last) will remain stored in the memory.
When a longer period of time elapses, however, the selection is reset to the status
established when the CAMERA<1> button was pressed.
The unit’s status indicator LED blinks green when a signal matched by the wireless remote
control ID has been received, and it blinks orange when a signal that is not matched by the
wireless remote control ID has been received.
When the wireless control in the web screen menu is set to “Off”, you cannot operate with
the wireless remote control. The power status indicator flashes orange rapidly (5Hz).
When operating with the wireless remote control, set the wireless control in the web screen
menu to “On”.
Содержание AW-UE20WP
Страница 95: ...95 MEMO ...
Страница 96: ...Web Site https pro av panasonic net en Panasonic Connect Co Ltd 2019 2022 ...