【
Controlling One AW-HE40 Camera via AW-RP50 Controller
】
①
Press MENU button. - (Fig. 1-A)
②
Press [10] SYSTEM button. - (Fig. 1-B)
*“
[1] CAMERA CTL” will be displayed on the LCD screen. - (Fig. 2)
*
If it is not displayed, turn F1 dial to make “[1] CAMERA CTL” appear.
③
While “[1] CAMERA CTL” is displayed on the LCD, press F1 dial. – (Fig. 1-C)
(“[1] CAM1” will be displayed on the upper half, and the connection method (default: [NoAsign]) on the
lower half of the LCD screen.)
*
If it is not displayed, turn F1 dial to make [CAM1] appear.
【
IP Connection
】
④
Turn F2 dial to select [Network], then press F2 dial to determine the setting.
– (Fig. 1-D)
【
Serial Connection
】
④
Turn F2 dial to select [Serial], then press F2 dial to determine the setting.
– (Fig. 1-D)
If the setting is executed correctly, the LED
marked with
〇
will light up according the
status display lamp of the camera.
Status Display Lamp
【
Serial Connection
】
【
IP Connection
】
Lit in Orange
・・・
Standby Mode (Factory Default)
Turning-on operation needs to be done.
Lit in Green
・・・
Turned-On State
(Image is being output.)
1.CAM1
Network
[
1
]
CAMERA
CTL
MENU ON
⇒
Select [10]
Press F1
Turn F2 to select
⇒
Press F2 to set
(Figure 1: AW-RP50 Control Panel)
(Figure 2: AW-RP50 LCD Panel)
(A)
(B)
(C)
(D)
2
.
Operating AW-RP50 Controller to Set Up the Network Connection with AW-HE40 Camera
(Status Display Lamp
・・・
Shows the camera’s power status)
1.CAM1
Serial