15
I
INCOM switches
[1/ 2]
This switch allows you to switch the intercom to be input to the
COMMUNICATION connector
between 1 and 2 to enable calls
with the selected camera.
Initial value: [1]
[4W/RTS]
This switch allows you to switch the system of the intercom signal to
be input to the COMMUNICATION connector
between 4-wire (4W)
and RTS.
Initial value: [4W]
z
z
When using the unit and camera combined on a one-to-one basis
instead of using the intercom equipment on the system side, set
this switch to the 4W position.
z
z
If you set this switch to the RTS position, be sure to connect an
RTS system.
z
z
When using the unit with an RTS system, terminate pins 1 and 3 of
the COMMUNICATION connector
using a terminating resistor
(200 Ω). (In the case of intercom signal 2, terminate pins 14 and
16.)
Refer to “Connector pin assignment table” of <Operations and
Settings> (page 38).
TALLY switch
[MAKE/V]
This switches the interface for the tally signal to be input to the
COMMUNICATION connector
between contact type (MAKE) and
voltage type (V).
Initial value: [MAKE]
K
AC power socket [AC IN ]
This socket is for inputting AC power.
Connect the supplied power cable, and use a 3-prong outlet and
ground the unit properly.
Grounding terminal [SIGNAL GND]
Connect this to the system ground.
Parts and their functions
(Continued)
