Panasonic AG-HPX500, Руководство по обслуживанию

Страница: 49 / 191

INF-39
8. UID Writing Procedure
< PREPARATION >
When UID is written, the PC EVR software is used. Please connect the tools and set up the PC EVR software
follow the item
“6. PC EVR software” .
< Writing Procedures >
1. This camera recorder is set to CAM mode.
2. Select “SYSCON(S)” section after start up the PC EVR software, and click “OK” button.
3. Select “Write UID” in “Tools(W)” menu, Write UID screen will appear on screen.
4. Input the last 8 figure numbers in
“UID P2” box. When the last 8 figure numbers are noted in advance, input
the same numbers as noted ones. If the last 8 figures are missed, new numbers are given. So please contact
the Panasonic Service Engineering.
5. Click “WRITE” button, the writing starts and following message is displayed.
6. Click
“OK” button.
NOTE: In case of write “SBP2 UID” , write UID follow the step 4 to 6 (Input the last 8 figure numbers in “SBP2
UID” box.).
7. Click “Re-Boot power” button on Write UID screen, the power of camera recorder automatically OFF and ON.
The operation of power OFF/ ON is required to save the number into the camera recorder
NOTE: When the “UID P2” and “SBP2 UID” are written at the same time, it is not necessary to perform the power
supply is OFF and ON individually.
8. Open the DIAGNOSTIC menu and confirm that the UID has been written in correctly.