30
31
GB
Cleaning the container and fan:
1. First empty the container and then
clean it using the cleaning brush.
(See figure 1).
2. Remove the fan housing and
clean the air intake/outlet using
the cleaning brush. (See figures 2
and 3).
3.
Do not clean the fan with water!
4. Remove the filter and then clean the
container. (See figure 4).
5. Clean the filter using a hair dryer or
with the cleaning brush (See figures
5 and 6).
6. After cleaning, put it firmly back in
place as it was before dismantling.
4.5 Installing/dismantling and cleaning the brushes
Installing/dismantling the main brush and the floor brush:
1. Push the locking bar backwards and
lift the cover with your right thumb;
then lift the central cleaning brush
using your left hand. (See figures 1
and 2)
2. Remove the main brush and the
rubber roller. (See figure 3)
3. Insert the main brush and the floor
brush into their corresponding holes
before closing the cover.
figure 1
figure 2
figure 5
figure 3
figure 4
figure 6
figure 1
figure 2
figure 3
Installing and dismantling the side brush:
Installation:
1. Loosen the screw in the main shaft
of the side brush before changing it.
Dismantling:
2. Push the side brush against the
main shaft and then tighten the
screw. (See figure).
Cleaning the side and floor
brushes:
1. For optimum cleaning, frequently
remove built-up hair and dust
from the rubber and floor rollers.
Clean any dust build-up on the air
intake. Remove waste paper or
dust directly using the dust brush.
Carefully rotate the brush and
cut out any built-up hair, threads
or other entangled objects using
scissors or pull them out by hand.
2. The main brush and rubber roller
can be cleaned following the
installation and dismantling section.
4.6. Installing/dismantling and cleaning the left/right wheel
1. Loosen the screw in the left/right
wheel using a screwdriver. (See
figure 1).
2. Remove the left/right wheel
and clean it with the brush (see
figure 2).
Do not clean with water!
3. Fit the left/right wheel in its original
position and tighten the screws
during installation.
figure 1
figure 2
