Palram 705949, Собрать

Страница: 15 / 19

EN
ADVANCED FEATURES
11.
Waterproof
R217 model is standard version which can be used in dry environment. R217-S is a IP68
waterproof version, which can be used in wet environment or under water within depth
of 30 meters.
Note: The remote receiving sensitivity will decrease when controller insta lled in wet
place or under water, please setup the controller when the main unit is dry.
12.
Protection
R217 series led dimmer has full protection function for output short circuit, overload,
and overheat.
The indicator will flash red at overload or short circuit protection and flash yellow at over heat.
The controller will automatically recover from protection when working status is good.
Please ensure the LED load is in rated range, not shorted and the controller unit is in a good
heat
dissipation environment to avoid protection.
SPECIFICATION
Model R217-S
Brightness Grade 7 levels
PWM Grade 256 256 levels
Min. Brightness Shortcut Yes
On/off status memorize Yes
Overload protection Yes
Overheat protection Yes
Working Voltage OC 5·24V
Remote frequency 433.92MHz
Remote control distance >15m at open area
Rated Output Current 15A
IP Grade IP-68
OPERATION
7.
Status Indicator
This is a full color status indicator. It displays all working status of the controller.
It indicates different events as following:
Blue: normal working.
Short single white flash : new command received.
Long single yellow flash : reach brightness limit.
Red flash : overload protected.
Yellow flash : overheat protected.
8.
Using Remote
Please pull out the battery insulating tape before using.
The remote controller use CR2032 cell battery, it can last for 2 years for regular usage.
For proper receiving remote signal, please do not install the controller in closed metal parts.
9.
Pairing New Remote
The remote and main unit is 1 to 1 paired as default.
Further more, one main unit can be paired to 5 remote controllers and every remote can
be paired to any main unit.
Please do following steps to pair a new remote:
1. Plug off the power of main unit and plug in aga in after more than 5 seconds.
2. Press remote ‘on/off’ and ‘decreasing brightness’ key together in 5 seconds after main unit
powered on.
After this operation, the controller’s indicator will flash white for 3 times to display the
new remote is accepted. The latest paired 5 remote controllers can be recognized.
10.
Optional Wall Switch Remote
The controller can also work with the optional wall switch type remote controller RM07.
This remote controller has the same function and usage as the default hand hold remote
controller.
It can be slicked on the wall for fixed place operation.
REMOTE DIMMER CONTROLLER - INFORMATION