7
•
This room heater must be installed in accordance with this advice to be covered by the Paloma warranty.
•
This room heater is suitable for indoor installation only.
•
This appliance must be installed in accordance with:
o
Local Gas Fitting Regulations
o
Municipal Building Codes
o
Australian Standard for Gas Appliance Installations AS/NZS5601.1:-2010
o
Any other relevant Statutory Regulation
o
Manufacturer’s installation instructions
•
This appliance must be serviced by a qualified person.
•
This heater must be installed with a minimum clearance of 50mm from the rear and sides. These
clearances must be maintained at all times.
•
There must be a minimum clearance of 750mm from the hot air outlet.
•
Do not install in a room with inadequate ventilation – refer to Australian Standard AS/NZS5601.1:-2010.
•
Do not install on an uneven surface or a vibrating floor.
•
Do not install directly on to carpet, timber floor, vinyl floor or cork floors. Heat emanating from these
appliances may discolour the carpet or damage your floor. It is recommended that a mat or flat board be
placed in front of this appliance extending at least 800mm in front of it.
•
Do not install near a door or windy location or under shelves or in a confined space. E.g.: fireplace.
•
Do not install in a bedroom, bathroom, combined living/sleeping areas, toilets or sauna.
•
Do not install where flammable materials are likely to come into contact with the heater.
•
Do not install where water may splash or near another heat source.
•
Do not install in a caravan, mobile home or recreational vehicle.
•
Do not connect to a Propane (LPG) gas cylinder
indoors
•
This appliance is not designed to be built into walls or cupboards.
.
•
If you move house check the gas type in the house where you are moving to.
•
The bayonet plug on the factory fitted flexible hose simply plugs into your bayonet fitting.
•
Do not place heater against wall or on a shelf.
•
Always place heater on flat surface and away from strong draughts.
•
It is recommended that a dedicated 240V 10Amp power point be used with this appliance. Do not use
power boards or double adaptors to operate this appliance. Heater must not be located adjacent to a
power socket – outlet.
•
Turn the heater off after use. Do not unplug the heater while it is in operation or while the fans are still
cycling.
•
Do not move the heater while it is in operation.
•
When the heater is operated for the first time or after long periods of non use a slight odour may be
emitted, this is normal. However if odours persist switch off the heater and contact Rheem Service.
Installation
