7
Palmgren Operating Manual & Parts List
80177
●
Apply lubricant to rack and pinion gear (Figure 7, Ref. Nos. 13 &
34) on column and table assembly.
CLEAN MOTOR
Frequently blow out any dust that may accumulate inside motor.
If power cord is worn, cut or damaged in any way, have it replaced
immediately.
IMPORTANT:
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment (other than those listed in this manual)
should be performed by authorized service centers or other qualified
service organizations, always sing identical replacement parts.
WARNING:
To avoid shock or fire hazard, if the power lead is worn
or cut in any way, replace it immediately.
REMOVE THE CHUCK
Refer to Figure 8.
●
With the switch “OFF” and the unit unplugged, adjust the depth
stop nut (Ref. No. 130) to hold the drill at a depth of 3 in. (7.6 cm).
●
Align the key holes in the spindle and quill by rotating the chuck
by hand.
●
Insert the key wedge (Ref. No. 142) into the key holes. Tap the key
wedge lightly with a plastic tipped hammer, until the chuck and
arbor fall out of the spindle.
NOTE:
Place one hand below the chuck to catch it when it falls
out.
DIGITAL DISPLAY PANEL
Refer to Figure 6.
●
Display panel (A) shows the spindle RPM.
●
Button (B) turns power on and off to LED light.
REVERSING SWITCH
Refer to Figure 10.
NOTE:
Only the drill press with the three-phase electric power
system has the reversible function.
●
The direction of the chuck rotation is controlled by the rocker
switch located at the left side of the ON/OFF switch base
(Ref.
No. 51).
WARNING:
The design of the switch will not permit changing the
direction of rotation while the drill press is running.
WARNING:
Turn switch off and remove plug from power source
outlet before maintaining or lubricating your drill press.
DRIVE BELT
Replace drive belt when worn.
LUBRICATION
Refer to Figures 7 and 8.
The ball bearings are lubricated at the factory and need no further
lubrication. Using 20wt. non detergent oil, periodically lubricate the
splines (grooves) in the spindle and the rack (teeth on the quill)
as follows:
●
Lower quill assembly (Figure 8, Ref. No. 147) all the way down.
●
Apply lubricant around the inside of the hole in the spindle
pulley (Figure 8, Ref. No. 158 & 172).
●
Apply lubricant to rack (teeth) on quill (Figure 8, Ref. No. 144)
while extended below drill press head.
Figure 6 – Digital Display Panel
A
B
MAINTENANCE
