10
| Pallas RO500
TUBE CONNECTION DIAGRAM
As shown in figure;
A: Connect feedwater to the water inlet of the
device.
B: Post carbon outlet must be connected to RO
faucet.
C: Wastewater tube must be connected to
outflow tube.
Use 3/8”drainage tube.
Stick the self-adhesive sponge seal in the was-
tewater clamp to the hole of the clamp.
Drill a 6 mm hole on the outflow tube.
Tighten the clamp (side with the seal) in correct
relative position of the hole to prevent any pos-
See: “Membrane Installation and Replacement”
on page 12.
MEMBRANE INSTALLATION
DRAINAGE (WASTE) TUBE INSTALLATION
sible water leakage. Make the seal connection
on the outflow tube . Ensure that the tube con-
nection will not loose.
Drainage connection –It must be connected in
such a way that the wastewaterflows out without
any flush or air swirl.
Ensure that the wastewater tube is not connec-
ted to the dishwasher waste or garbage disposal
outflow line because it can result in back-pres-
sure and so, overflow.
After these steps, RO unit is ready to be installed.
RO FAUCET
Waste Water
Water Inlet
B
B
A
