USERS MANUAL |
11
START-UP AFTER INSTALLATION
Once you have assembled and installed all the compo-
nents, turn on the water supply first tocheck for leaks.
Then, turn on the faucet slowly. At the first stage, water
will run from the faucet slowly. Let it run in this way for
10 minutes. If the waterstarts to drip and do not reach
normal flowrate, it probably means that the water pres-
sure isso low that the device cannot perform with 100
% efficiency. If you are experiencing such a problem,
see Troubleshooting on page 17.
Now your device is ready for usage, you can enjoy qu-
ality water safely.
There is a pre-set amount of air in the water
tank. Please do not touch the air valve.
There is no need to use teflon band for installa-
tion of tank tap because there is an o-ring at the
connection point.
Tank tap can be connected easily with hand wit-
hout using pliers. Please do not tighten much.
*During the first few days after installation, airbubbles
may be seen in the water.
*Water treatment device will work better andl longer when
it is used more often. For this reason, we recommend you
use the purified water for cooking, preparing tea, coffee etc.
*In case of water leaks, broken filters etc., turn off the valve
of water supply and correct the faults.
!! IMPORTANT !!
20” 5 Micron Spun (Sediment) Filter:
It should be replaced approximately every 6
months depending on the water contamination.
20” GAC Carbon Cartridge Filter (UDF):
If the water is clear and the total amount of chlorine
is low, the cartridge life is 6 months on average.
20” Block Carbon Cartridge Filtre (CTO):
The cartridge life is approximately 6 months
depending on the amount of chlorine in the water
and replecament periods of pre-filters.
Membrane Filter:
The membrane life is approximately 3 years
depending on the regular maintenance.
12” Inline Coconut Post Carbon Filter:
The cartridge life is approximately 12 months.
REPLACEMENT PERIODS OF CARTRIDGE FILTERS
MAINTENANCE AND CLEANING
TANK TAP INSTALLATION
If the cartridge filters have packages, remove
them and insert in proper housings according to
the order shown in the installation diagram. Screw
bottoms of housings back onto caps securely, if ne-
cessary, use teflon or gasket to prevent possibility
of any leakage.
Filters must be washed to sanitize dust and partic-
les before they are used (check the washing proce-
dures on page 12).
INSTALLING CARTRIDGES
Tank tap should be installed in models with tank.
