Palfinger RC 400 P2, Руководство по эксплуатации

Страница: 11 / 18

Remote control operation
3-2
3-2 Remote control operation
Switch on power take-off.
Put the switch on the crane into the middle
position (remote control operation).
Carry the remote control transmitter using the supplied belt.
To be able to run evenly and precise crane movements use the car-
rying strap for the remote control panel.
Secure standing position of the operator:
The operator’s standing position must be outside of the crane’s danger zone.
The operator must have clear view of all crane movements for loading and unloading jobs.
Starting remote control system:
•
Move lever in neutral position.
•
Release the emergency stop button on the remote control console.
•
Press the start button (3) on the remote control panel.
Remote control ready for operation.
Before unfolding the crane it is necessary to support the vehicle properly.
After unfolding the crane check the emergency off function (for the test procedure see crane emer-
gency off switch operating instructions, chapter 4).
If malfunctions occur during crane operation let go all operating
levers immediately and press the emergency off switch until it locks.
Use of the remote control is only permitted after the failure has been
repaired in an authorized Palfinger service center.