Palfinger RC 400 P2, Руководство по эксплуатации

Страница: 15 / 18

Remote control operation
3-6
3-6 Cable winch working position and transport position
small big
To put the cable winch in its working position or transport position, you have to hold down the switch
(1, release) and the additionally press down the flip switch (2; a = transport position, b = working
position). Upon reaching the respective position, an acoustic signal will sound
3-7 Remote operation safety switch-off
The remote control transmitter will be automatically switched off in case of:
•
Radio interferences.
•
Exceeding the maximum range.
•
Defective remote control system.
•
Discharged battery.
•
A crane function has not been operated for more than 5 minutes.
To continue work restart the remote control transmitter (3-1, 3-2).
Defective remote control systems must not be taken into operation. The
defect has to be repaired by an authorized Palfinger service center.
* The time can be customized in your service center.
3-8 Changing the radio channel (in case of radio interference)
Press start button (3) briefly twice Successful channel change is indicated by a short acoustic signal.
3-9 Cable operation
A 15 m long cable is delivered with each unit. This cable must be connected to the transmitter and the
receiver. No radio signals are sent during cable operation, as cable operation has a higher priority
than remote control operation. If the battery is loaded, it will be automatically re-charged.