Palazzetti WILMA, Использование и функциональность

Страница: 25 / 68

ENGLISH
4.2 “ECO MODE” SAVING FUNCTION
Enabling this function means that the stove switches off when reaching the desired room temperature. If
this function is not enabled, the stove modulates operation so as to maintain the desired temperature while
consuming the least amount of fuel possible. The “Eco Mode” function is only available in con
¿ guration 2.
To enable/disable the function:
a) Use the arrow buttons to go to the setup menu and then press ;
b) Use the button to select the password “7” and then press to con ¿ rm;
c) Select submenu [7] and con ¿ rm by pressing .
d) Set one of the following values using the buttons:
Eco ĺ Enable "Eco Mode” function
Off ĺ Disable “Eco Mode” funcition
e) Press
to con ¿ rm the settings.
4.3 RESTARTING AFTER A POWER FAILURE
In the event of power failures, the stove will switch back on automatically, checking the safety conditions, when
power returns.
4.4 “LOCK KEYPAD” FUNCTION
This function is used to disable the use of the control panel and avoid accidental modi ¿ cations.
To enable/disable the function:
a) Use the arrow buttons to go to the setup menu and then press ;
b) Use the button to select the password “7” and then press to con ¿ rm;
c) Select submenu
[10]
and con ¿ rm by pressing
.
d) Use the buttons to set one of the following values:
“
Off
”
Lock keypad disabled
“
Lo
”
Only the on/off button is enabled
“
Hi
”
Lock keypad enabled
e) Press
to con
¿ rm the settings.
4.5 FROST PROTECTION FUNCTION
In con ¿ gurations 2, 3 and 4 a minimum temperature can be set below which the boiler will switch on (outside of
the set time bands).
&RQ¿JXUDWLRQ
To set the “frost protection” temperature:
a) Use the arrow buttons to go to the setup menu and then press ;
b) Use the button to select the password “7” and then press to con ¿ rm;
c) Select submenu [9] and con ¿ rm by pressing ;
d) The value will À ash; change it using the buttons ( OFF ; 3...20 ƒ C);
e) Press to con ¿ rm the settings.
Con ¿ guration 3 and 4:
To set the “frost protection” temperature:
a) Use the arrow buttons to go to the setup menu and then press ;
b) Use the button to select the password “7” and then press to con ¿ rm;
c) Select submenu
[9]
and con ¿ rm by pressing ;
d) The value will À ash; change it using the buttons ( OFF ; 3...50 ƒ C);
e) Press to con ¿ rm the settings.
Setting the value to “OFF” in step d disables the function.
25