Painless Performance Products PERFECT TORC, Руководство по установке

Страница: 31 / 37

31
TROUBLESHOOTING ERROR MESSAGES
WARNING! If the transmission does not begin to operate correctly
within the first few feet of the road test, STOP immediately, check the
for error messages, and troubleshoot. In some cases, just a few
blocks of operation with low fluid pressure can destroy a
transmission.
Error Messages
When the Torc Module detects an error, it will show one of the following error
messages on the home screen. If there are multiple errors, it will cycle
through them on the home screen. Error messages can also be viewed in
Controller Fault Display in the tuning software. History is cleared when the
controller powers down completely (ignition turned off and USB cable
removed from computer.) It is a good idea to periodically check the display
for errors as you drive, so it is wise to consider an accessible mounting
location.
Battery voltage is too low
The voltage to the controller has dropped below 8 volts.
Battery voltage is too high
The voltage to the controller is above 17.2 volts.
Shift Solenoid A (SSA) overcurrent error
An over-current condition was detected on the indicated shift solenoid. A short circuit may
be present in the solenoid circuit. The controller will attempt to disable the solenoid with
the over-current condition until the ignition is turned off.
Shift Solenoid B (SSB) overcurrent error
An over-current condition was detected on the indicated shift solenoid. A short circuit may
be present in the solenoid circuit. The controller will attempt to disable the solenoid with
the over-current condition until the ignition is turned off.
3-2 D/S Solenoid overcurrent error
An over-current condition was detected on the 3-2 downshift solenoid. A short circuit may
be present in the solenoid circuit. The controller will attempt to disable the solenoid with
the over-current condition until the ignition is turned off.