11
Installation Steps: Vehicle Harness
1.
The Vehicle Harness has a 16 pin connector that plugs into the left side of the
TORC Module. See Figure 2
on page 8 for the connection. See Diagram 3 on
page 15 for a diagram identifying the wires in this connector.
2.
See below
for a detailed list of all the individual connections needed for the
Vehicle Harness with this system.
A. Red Wire Labeled
– “Ignition Switched Power”
Connect to a 12volt power source that has power when the Ignition Switch
is in the
“On/Run” and “Start” position. Splices and a Posi-Tap have been
provided to make this connection.
Posi-Tap Instructions
1. Unscrew the larger cap from the end of the Posi-Tap. The slot in this cap
will slide over the existing wire you are tapping into.
2. Screw the body of the Posi-Tap
onto the cap, watching the needle
of the body to insure it pierces the
wire insulation.
3. Strip about 3/8 of an inch of
insulation from the wire coming
from the module.
4. Remove the small cap from the end
of the Posi-Tap body and thread
the stripped wire into the end of the
cap. Push the wire into the body of
the Posi-tap and tighten the cap
back onto the Posi-Tap body.
A. Red Wire
– “Ignition Switched Power”
B. Black Wire(s)
– “System Ground One” and “System Ground Two”
C. Green Wire
– “Throttle Position Sensor”
D. Orange Wire
– “+5 Volt Feed” Throttle Position Sensor
E. Tan Wire
– “Speedometer Signal Output”
F. Yellow Wire
– “Engine RPM Input”
Содержание PERFECT TORC
