Painless Performance Products PERFECT TORC, Руководство по установке

Страница: 36 / 37

36
Checksum error in table
A Checksum error has been found in the calibration table. It will also disable saving Setup
Menu changes and disable the tuning menu. Connect the controller to a PC and load a
calibration using Shiftware.
Torque Converter Clutch Slip Error
Torque converter clutch slip detected when fully engaged.
Transmission Slip in Gear(s) 1, 2, 3, etc.
Transmission appears to be slipping in the indicated gear or gears.
Transmission Slip with Max Pressure
Transmission continued to slip after maximum line pressure was commanded.
Transmission Slip Repeated > 2x
Transmission slip was detected more than twice in this drive cycle (max. line pressure
latched).
Ratio too High in Gear(s) 2, 3, 4, etc.
Transmission gear ratio appears to be too high in the indicated gear or gears.
Error: PRNDL Out of Range
Sensor voltage is out of tolerance limits, but within approximate range.
Error: PRNDL Signal Low
Sensor voltage is low.
Error: PRNDL Signal High
Sensor voltage is high.
Error: No PRNDL PWM Signal
Connect the controller to a PC and use Shiftware to reload the calibration using a
calibration that matches your transmission.
Error: Invalid PRNDL Code=XX-XX
DTR or PSM signal combination not valid. XX-XX indicates high/low status of all 4 DTR
pins (1 or 0)
Low-Side Driver Shorted
A low-side output driver appeared to be shorted on during power-on solenoid check.
Contact Baumann Electronic Controls technical support for assistance.