3
INSTALLATION
First, decide what switches will be used for your
application and install them into the panel. Start by
adjusting the hex shaped backing nut on each of the
switches ¾ of the way back toward the body of the switch.
Insert the switch through the switch hole opening
with the slot on the threads facing down and screw the black
toggle switch boot onto the front of switch by hand until
snug.
Next, using either a
5
∕
8
”
or a
16mm
deep wall
socket hold the switch boot in place while tightening
the hex shaped backing nut to fully secure the switch
to the panel. Tightening the switch using the nut
inside the switch boot could damage the shoulders
around the boot.
In order to allow the maximum amount
of room for the switch labels, line the switch
boots up with the flat sides of the hex-shaped
nut running parallel with the top and bottom
sides of the switch panel.
Follow this same procedure for
installing the push button circuit breakers.
NOTE: A thread locker may be used to assist in keeping the switch and circuit
breaker mounting nuts from vibrating loose.
Install the push button start switch into the switch panel. Tighten the weather-
resistant retaining nut by hand.
NOTE: A thread locker may be used to assist in
keeping the start button nut from vibrating loose.
The large spliced red wire assembly is included to provide power from the battery
to the switch panel.
