Paderno 085-0001-6, Руководство пользователя

Страница: 12 / 48

Gas Connection
LP TANK REQUIREMENT
A dented or rusty LP tank may be hazardous and should be checked by your LP supplier. Never use a
cylinder with a damaged valve. The LP gas cylinder must be constructed and marked in accordance
with the specifications for LP gas cylinders of the U.S. Department of Transportation (DOT) or the
National Standard of Canada, CAN/CSA-B339, Cylinders, Spheres and Tubes for Transportation of
Dangerous Goods; and Commission, as applicable.
For use with a standard 20 lb LP cylinder: 18 1/4” (470 mm) high, 12 1/4” (305 mm) diameter. Overfill-
ing prevention device (OPD) shall be provided on cylinder and QCCI connection on the cylinder valve,
ANSI/CGA-V-1. The cylinder supply system must be arranged for vapour withdrawal. The cylinder must
include a collar to protect the cylinder valve. The cylinder must be provided with a shut off valve termi-
nal in an LP gas supply cylinder valve outlet specified, as applicable, for connection type QCC1 in the
standard for compressed gas cylinder valve outlet and inlet connection ANSI/CGA-V-1.
Manifold pressure: 11” water column (W.C.).
LP GAS HOOK-UP
Ensure that the black plastic grommets on the LP cylinder valve are in place and that the hose does not
come into contact with the pizza oven.
CONNECTION
Your pizza oven is equipped with gas supply orifices for use only with liquid propane gas. It is also
equipped with a hose/regulator assembly for connection to a standard 20 lb LP cylinder.
To connect the LP gas supply cylinder, please follow the steps below:
1. Make sure tank valve is in its full off position (turn clockwise to stop).
2. Check tank valve to ensure it has proper external male threads (type 1 connection per ANSI Z21.81).
3. Make sure the burner valve is in the off position.
4. Inspect valve connections, port, and regulator assembly. Look for any damage or debris. Remove
any debris. Inspect hose for damage. Never attempt to use damaged or obstructed equipment. See
your local LP gas dealer for repair.
5. When connecting regulator assembly to the valve, hand tighten the quick coupling nut clockwise to
a complete stop. Do not use a wrench to tighten. Use of a wrench may damage the quick coupling
nut and result in a hazardous condition.
6. Open the tank valve fully (counter-clockwise). Apply the soap solution with a clean brush to all gas
connections. See below. If growing bubbles appear in the solution, the connections are not properly
sealed.
7. Check each fitting and tighten or repair as necessary.
8. If you have a gas connection leak you cannot repair, turn gas OFF at supply tank, disconnect fuel
line from your pizza oven and call 1-800-263-9768 or your gas supplier for repair assistance. Also
apply soapy solution to the tank seams. If growing bubbles appear, shut tank OFF and do not use or
move it. Contact an LP gas supplier or your fire department for assistance.
12
TM