PART NO.
IMAGE
DESCRIPTION
QTY
AC-LHA-PEM
Pendant Mount Kit bracket for Linear High
Bay
1
FLHA-ME-P
Cover Plate for the AC-LHA-PEM Pendant
Mounting Kit.
2
10-00071
Hex Head Bolt
4
10-00026
Pan Head M4-0.7 x 6mm Long Screw
4
10-00063
Washer for M4 Screw
4
10-00065
Lock Washer for M4 Screw
4
CAUTION:
PLEASE FOLLOW THIS INSTRUCTION MANUAL CAREFULLY TO
PREVENT ANY INJURIES OR COMPLICATIONS THAT MAY ARISE.
WARNING:
Before installing or maintaining the luminary, make sure all powers are
TURNED OFF
.
Verify that supply voltage is correct by comparing it with the label information on all
fixtures.
Make all connections in accordance with the NEC requirements, and make sure all
luminaries are properly secured to prevent any wire complications. This luminary is
to always be installed with the lens facing down and its not to exceed the maximum
ambient temperature rating noted on the specification sheet.
USHIBAYLxxxWPL Series LED Highbays Installation Guide
Step 1:
Fasten the FLHA-ME bracket
!
to the luminaire using the
!
Hex Head
machine screws provided
!
along with
one washer and lock washer in order
to screw the bracket
!
into place.
Linear Highbay Pendant Mount Kit
Step 2:
Once the Pendant Bracket is installed
onto the fixture. Fasten a 3/8” IPS
!
conduit to the bracket from the hole
!
on the top side of it using a lock nut
!
that matches the thread on the 3/8”
!
IPS conduit. Run the AC Power cables
!
down the conduit and fasten them to
!
the input cables of the Driver. This
!
might require the customer to remove
!
to cap from the luminaire.
Step 3:
Once all wiring is complete,
use the two cover tabs that
are provided to cover
the sides of the Pendanct bracket.
Step 4:
Use the two remaining screws
to fasten the cover plates into
place.
Step 5-
Remove the cover plate in
order to access wires required for
installation. Have an AC Power
Supply Conduit with a J-Box
attacked to the ceiling come down
to approximately the same height
of the chains. Use the Wiring
Diagram provided above to
properly wire the luminaire to the
power supply. All wiring
connections must be made either
inside a Junction Box or the back
housing of the luminaire.