PART NO.
IMAGE
DESCRIPTION
QTY
AC-LHA-SMS
Surface Mount Kit bracket for Linear High
Bay
AC-LHA-SMS: 090/110/178/223
2
AC-LHA-SML
Surface Mount Kit bracket for Linear High
Bay
AC-LHA-SMS: 162 or 321
2
10-00071
Hex Head M6-1.0 x 20 mm Long Bolt
4
10-00063
Washer for M6 Bolt
4
10-00065
Lock washer for M6 Bolt
4
CAUTION:
PLEASE FOLLOW THIS INSTRUCTION MANUAL CAREFULLY TO
PREVENT ANY INJURIES OR COMPLICATIONS THAT MAY ARISE.
WARNING:
Before installing or maintaining the luminary, make sure all powers are
TURNED OFF
.
Verify that supply voltage is correct by comparing it with the label information on all
fixtures.
Make all connections in accordance with the NEC requirements, and make sure all
luminaries are properly secured to prevent any wire complications. This luminary is
to always be installed with the lens facing down and its not to exceed the maximum
ambient temperature rating noted on the specification sheet.
USHIBAYLxxxWPL Series LED Highbays Installation Guide
Step 3:
After the luminaire
!
is
properly secured into place, use
!
the Wiring Diagram to install the
!
luminaire to an AC Power Supply.
!
All connections must be made
inside a J-Box. (J-Box not included)
Step 1:
Mount the brackets to the Mounting
surface desired. The Surface Mount does NOT
INCLUDE a Junction Box or Mounting screws.
These will have to be provided by the customer.
The following figure is a detail of the mounting
holes on the bracket.
Step 2:
Once the Mounting
!
Brackets are Installed onto
!
the surface and properly
!
secured. Use the two holes
on the bottom slanted surface to
!
fasten the luminaire. This
!
is
done by using the M6-1.0
!
bolt
along with the lock-washer
!
and
washer.
Linear Highbay Surface Mount Kit
Step 4:
Once the Mounting
!
Brackets are Installed onto
!
the surface and properly
!
secured. This is how the
!
luminaire should look.
Step 5-
Remove the cover plate in
order to access wires required for
installation. Have an AC Power
Supply Conduit with a J-Box
attacked to the ceiling come down
to approximately the same height
of the chains. Use the Wiring
Diagram provided above to
properly wire the luminaire to the
power supply. All wiring
connections must be made either
inside a Junction Box or the back
housing of the luminaire.
