PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off
top and right edge. Left side of page extends to 9.25 inches.
Note: SCSI termination is automatic and requires no
user configuration
16
Power on the DEU subsystems. After the power-on
self-test has completed, HDD Status and Channel
Mode LEDs will be solid green.
17
Access the Options menu on the Operator Control
Panel and choose the SAFTE CHAIN ID selection.
Set the cabinet identities of the master and slave
subsystems. Refer to “SAFTE CHAIN ID” in the DEU
User’s Guide.
18
After setting the cabinet identifications you must
power cycle the subsystems. Observe normal power
cycling precautions by waiting a minimum of five
seconds before adding power again.
This will reset the SCSI IDs to a default setting that
prevents a SCSI ID conflict under normal conditions,
refer to “Default Configurations” later in this section.
19
Power up your computer system and run the
configuration program.
This completes the setup and configuration.
