Packard Bell EasyNote NM85, Руководство по обслуживанию

Страница: 63 / 142

www.packardbell.com
57
Replacing the LED board
Tools you need to complete this task:
Screws removed during this task:
•
1 black M2×3 (hard drive)
•
1 black M2.5×6 (optical drive)
•
2 M2.5×6 black (palm rest - top side)
•
6 M2×3 black (palm rest - base side) - Indicated by A
in step 13 of the “Replacing the palm rest” procedure on page 49
•
9 black M2.5×6 (palm rest - base side) -
Indicated by B in step 13 of the “Replacing the palm rest” procedure on
page 49
•
2 black M2×4 (LED board)
To replace the LED board:
1
Complete the steps in “Preparing the notebook” on page 37 .
2
Complete the steps in “Removing the battery” on page 38 .
3
If the notebook has a wireless card installed, remove the card from the old
system board and install it on the new system board by following the
instructions in the “Replacing the wireless card” section on page 43 .
4
Remove the hard drive by performing steps 3 and 4 of the “Replacing the
hard drive” procedure on page 40 .
5
Remove the optical drive by performing steps 3 and 4 of the “Replacing the
optical drive” procedure on page 45 .
6
Remove the palm rest by following steps 7 – 16 of the “Replacing the palm
rest” procedure on page 49 .
7
Turn the palm rest so that its underside is facing up.
Phillips #0 screwdriver
Flat screwdriver or Non-marring plastic scribe