Pacific Scientific MA6410, Руководство по установке и аппаратным средствам

Страница: 21 / 80

Wiring is
application
specific
Wiring sizes, wiring practices and grounding/shielding techniques
described in the following section represent common wiring
practices and should prove satisfactory in the majority of
applications.
Caution
Non-standard applications, local electrical codes, special
operating conditions, and system configuration wiring needs take
precedence over the information included here. Therefore, you
may need to wire the drive differently then described here.
Noise pickup
reduction
Use shielded and twisted cabling for the signal and power cables
as described below. This precaution reduces electrical noise.
Shock hazard
reduction
Refer to section 2.2 for safety information that must be followed
to reduce shock hazard.
2.5.1 J3 Mo tor Con nec tions
Introduction
The J3 motor cable connects the controller to the motor windings
and motor case. J3 utilizes a plug-in screw terminal/type
connector to simplify assembly and allow quick connect and
disconnect.
Pacific Scientific
cable
Pacific Scientific makes cables that connect directly from J3 to our
system motors. To order the cable from Pacific Scientific, use the
order number SPC-xxx-6410, where “xxx” is the length, in feet
(one-foot increments) up to 50 feet. For example, SPC-050 is a
cable 50 feet long.
6410 Installation and Hardware Reference Manual - Rev E 2 - 9
StockCheck.com