Page 14
SKU 97553
For technical questions, please call 1-800-444-3353.
To increase the pressure, turn the
5.
Pressure Regulator Knob towards the
“
+
” symbol.
Hold the Wand at about a 45° angle
6.
when cleaning; spraying the surface
directly could embed dirt into the
surface (especially with the high pres-
sure Nozzles). Spray at a distance of
about three to five feet.
Clean vertical and sloped surfaces
•
from the top down.
When cleaning horizontal surfaces,
•
occasionally use the stream to clear
the area of excess water to improve
safety.
never allow the
Pressure washer
to idle, without the trigger
depressed, for more than two
minutes. the water will heat
up and could damage the
Pressure washer.
Hold the Trigger down and move
7.
the Wand back and forth slowly and
steadily to pressure wash the surface.
Take special care when spraying sur-
faces made of two different materials
(brick and mortar, for example), to not
damage the softer of the two materi-
als during pressure washing.
If the surface is streaked or uneven
8.
at the end of a job, switch to a Nozzle
that has a wider spray pattern to
blend the affected area.
When finished; release the Trigger on
9.
the spray handle, turn the water sup-
ply off, turn the engine’s power switch
“OFF” and then shut off gas supply to
the engine.
Squeeze the Trigger to release ex-
10.
cess pressure.
If Pressure Washer detergent has
11.
been used for the job, run clean
water through the system to eliminate
detergent residue.
To prevent accidents, turn off the
12.
engine, wait for it to cool, and discon-
nect its spark plug wire after use.
Drain all water out of the unit, clean
external parts with clean cloth, then
store the equipment out of children’s
reach according to the Storage in-
structions in this manual.
cautiOn
