Page 13
SKU 97553
For technical questions, please call 1-800-444-3353.
starter handle with a rapid, full arm
stroke. Once again while holding
the handle, allow the rope to rewind
slowly. Repeat as necessary, until
the engine starts.
After the engine starts and warms
5.
up, slowly move the choke lever to its
“RUN” position.
IMPORTANT: Allow the engine to
6.
run at no load for five minutes with no
load after each start-up so that the
engine can stabilize.
break-in Period
Breaking-in the engine will help to
1.
ensure proper equipment and engine
operation.
The operational break-in period will
2.
last about 3 hours of use. During this
period:
Do not apply a heavy load to the
•
equipment.
Do not operate the engine at its
•
maximum speed.
The maintenance break-in period will
3.
last about 20 hours of use. After this
period:
Change the engine oil.
•
Under normal operating conditions
subsequent maintenance follows the
schedule explained in the MAINTE-
NANCE AND SERVICING section.
equipment Operation
Choose the Nozzle that best meets
1.
the needs of the job. Only use the
Nozzles on surfaces capable of with-
standing the force of the spray
never direct spray
from the pressure
washer at a person or animal.
the water stream could cause
serious injury.
Only use the
pressure washer
on surfaces able to withstand
the force of the spray.
Only use the black
nozzle when using
pressure washer detergent.
the power of the other
nozzles will propel mist back
at the operator and can imbed
the detergent into the surface.
Pull back the quick connect collar and
2.
push the Nozzle onto the end of the
Wand. Make sure the quick connect
collar locks the Nozzle in place.
Turn the water supply on and hold
3.
down the Trigger to start the stream.
Be aware that when it is first started,
the gun will kick.
It is best to start at a low pressure
4.
setting and adjust the pressure up-
wards. Test spray the edge of the
surface to be cleaned first to make
sure that the stream is not too strong
for the surface. If the stream dam-
ages the surface turn the Pressure
Regulator Knob towards the “
—
” to
reduce the pressure. Moving further
away from the surface being cleaned
will also reduce the pressure being
applied to the surface. If the stream
is still too strong. Turn the water sup-
ply off, turn the engine off, discharge
the excess pressure from the gun by
squeezing the Trigger, and change to
a lower pressure Nozzle.
danger
cautiOn
cautiOn
