Pacific Floorcare S-24XM, Инструкция по эксплуатации и каталог запасных частей

Страница: 20 / 52

TROUBLESHOOTING GUIDE
20
ISSUE POTENTIAL CAUSE PROPOSED SOLUTION MANUAL SECTION
INSUFFICIENT WATER TO SCRUB HEAD
SOLUTION FLOW SETTING IS TOO LOW ADJUST SOLUTION CONTROL
SOLUTION
DISTRIBUTION
SOLUTION TANK IS EMPTY ADD WATER/SOLUTION TO THE TANK
SOLUTION
DISTRIBUTION
INLINE SOLUTION FILTER IS CLOGGED REMOVE AND CLEAN THE FILTER
SOLUTION
DISTRIBUTION
SOLUTION TUBE IS CLOGGED, KINKED, OR DAMAGED INSPECT TUBES PARTS DIAGRAMS
SOLUTION SHUT OFF VALVE IS CLOSED OPEN VALVE
SOLUTION
DISTRIBUTION
SOLUTION SOLENOID VALVE MAY BE FAULTY VERIFY OPERATION AND REPLACE IF NECESSARY PARTS DIAGRAMS
POOR WATER RECOVERY
RECOVERY TANK IS FULL EMPTY RECOVERY TANK RECOVERY SYSTEM
DIRTY OR WORN SQUEEGEE BLADES INSPECT AND ROTATE OR REPLACE AS REQUIRED RECOVERY SYSTEM
RECOVERY HOSE LOOSE OR DAMAGED INSPECT AND REPAIR PARTS DIAGRAMS
RECOVERY HOSE OR SQUEEGEE ASSEMBLY HAS AN
OBSTRUCTION
CLEAR OBSTRUCTIONS FROM RECOVERY SYSTEM PARTS DIAGRAMS
SQUEEGEE ASSEMBLY MAY BE OUT OF ADJUSTMENT ADJUST AS NECESSARY RECOVERY SYSTEM
STUCK OR DAMAGED BALL FLOAT INSPECT AND REPAIR/REPLACE RECOVERY SYSTEM
RECOVERY TANK LID IS NOT SEALING PROPERLY
INSPECT RECOVERY LID GASKET. REPAIR OR
REPLACE IF NEEDED
PARTS DIAGRAMS
DRAIN HOSE CAP IS NOT INSTALLED PROPERLY INSTALL DRAIN HOSE SECURELY RECOVERY SYSTEM
LOW BATTERY VOLTAGE CHARGE BATTERIES CHARGING
MACHINE WILL NOT TURN ON
FAULTY KEY SWITCH DIAGNOSE AND REPLACE WIRING DIAGRAM
DISCHARGED BATTERIES CHARGE BATTERIES CHARGING
LOOSE OR DAMAGED WIRE REPAIR WIRING DIAGRAM
MACHINE NOT CLEANING FLOOR PROPERLY
WORN PAD OR BRUSH INSPECT AND REPLACE AS REQUIRED SCRUB DECK SETUP
WRONG PAD OR BRUSH FOR APPLICATION
CONTACT YOUR LOCAL DISTRIBUTOR FOR
RECOMMENDED APPLICATION
SCRUB DECK SETUP
INSUFFICIENT CLEANING SOLUTION FOR APPLICATION ADJUST THE MIXTURE AS REQUIRED
SOLUTION
DISTRIBUTION
EXCESSIVE FOAM IN RECOVERY TANK IMPROPER DETERGENT TYPE
USE A LOW-FOAM DETERGENT OR ADD A DEFOAMING
AGENT TO THE RECOVERY TANK. READ ALL
CHEMICAL LABELS THOROUGHLY BEFORE USE
RECOVERY SYSTEM
VACUUM MOTOR WILL NOT RUN
SQUEEGEE LIFT LEVER IS STILL RAISED LOWER SQUEEGEE LEVER RECOVERY SYSTEM
VACUUM RELAY MAY BE FAULTY
CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT
AND ISOLATE
WIRING DIAGRAM
VACUUM SWITCH OR WIRING MAY BE FAULTY
CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT
AND ISOLATE
WIRING DIAGRAM
RETURN TO
TABLE OF
CONTENTS