Pacific Floorcare RS28, Инструкция по эксплуатации и каталог запасных частей

Страница: 16 / 58

RETURN TO
TABLE OF
CONTENTS
- 13 -
CHEMICAL INJECTION
INSPECTION & CLEANING
For machines equipped with the optional chemical injection system:
1. Place a 1-gallon chemical container in the holder (located behind the battery
compartment, under the Recovery Tank).
2. Insert the hose into the container so that the filter at the end of the hose rests on the
bottom of the container.
3. Screw on the cap.
4. Match the mix ratio dial on the Control Panel to the setting (in ounces per gallon)
prescribed by the chemical manufacturer.
5. Set the SOLUTION FLOW selector to the desired flow setting.
6. Operate the machine as normal.
NOTE
: If the chemical is not priming, temporarily set the mix ratio to a higher setting until
the chemical is delivered.
NOTE : To purge chemical, remove the hose from the chemical container, set the mix ratio
dial to the highest setting, and run until the hose is drained.
To clean out the solution tank in the case of excessive debris:
1. Close the shutoff valve (located under the left rear tire).
2. Remove the filter bowl and screen (located forward of the
shutoff valve).
3. Open the shutoff valve and allow the tank to drain.
4. Rinse the solution tank thoroughly.
5. Install the filter bowl and screen.