Pacific Floorcare RS28, Инструкция по эксплуатации и каталог запасных частей

Страница: 27 / 58

RETURN TO
TABLE OF
CONTENTS
- 24 -
ISSUE POTENTIAL CAUSE PROPOSED SOLUTION
VACUUM MOTOR WILL NOT
TURN OFF
STILL IN DELAY MODE ALLOW 30-45 SECONDS FOR VACUUM TO SHUT DOWN
FAULTY MAIN CONTROLLER INSPECT AND REPLACE AS REQUIRED
SCRUB HEAD WILL NOT RUN
SCRUB HEAD IS STILL RAISED LOWER SCRUB HEAD
BATTERYSHIELD® LED IS ILLUMINATED AND HAS DISABLED THE SCRUB HEAD SERVICE THE BATTERIES
SOLUTION TANK IS EMPTY - LED IS ON
ADD WATER/SOLUTION TO THE TANK
BRUSH MOTORS TRIPPED OVER-CURRENT PROTECTION TURN THE MACHINE OFF AND BACK ON
OPERATOR CONTROL BOARD IS DAMAGED VERIFY OPERATION AND REPLACE IF NECESSARY
HEAD LIFT POSITION SENSOR IS DAMAGED INSPECT AND REPLACE AS REQUIRED
BATTERIES ARE DISCHARGED BELOW THRESHOLD VOLTAGE CHARGE BATTERIES
SCRUB HEAD LIFT ARM SWITCH MAY BE STUCK OR FAULTY INSPECT AND REPAIR SWITCH AS REQUIRED
SCRUB HEAD OVER-CURRENT
PROTECTION IS TRIPPED
INADEQUATE SOLUTION FOR APPLICATION INCREASE SOLUTION TO SCRUB HEAD
SCRUB HEAD IS SET TO HEAVY DOWN PRESSURE REDUCE DOWN PRESSURE SETTING
PAD IS TOO AGGRESSIVE FOR APPLICATION CONTACT YOUR LOCAL DISTRIBUTOR FOR RECOMMENDED APPLICATION
FAULTY OR SHORTED WIRE REPAIR
SCRUB HEAD WILL NOT LOWER/
RISE
MECHANICAL INTERFERENCE REPAIR
SCRUB HEAD ACTUATOR POSITION SENSOR/WIRING LOOSE OR DAMAGED INSPECT AND REPAIR. CALIBRATION OF SENSOR IS REQUIRED.
MACHINE WILL NOT DRIVE
MAIN FUSE MAY BE BLOWN INSPECT AND REPLACE. IF PROBLEM PERSISTS CONTACT SERVICE TECHNICIAN
BATTERY METER IS FLASHING A FAULT CODE REFERENCE FAULT CODE AND TROUBLESHOOT AS REQUIRED
BATTERIES DISCHARGED TOO LOW CHARGE BATTERIES
SEAT SWITCH IS NOT TRIPPED INSPECT AND REPLACE AS REQUIRED
THROTTLE PEDAL OR PEDAL WIRES ARE DAMAGED VERIFY OPERATION AND REPLACE IF NECESSARY
BRAKE IS NOT DISENGAGING INSPECT AND REPLACE AS REQUIRED
FAULTY CONTROLLER CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT AND ISOLATE
FAULTY WIRING CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT AND ISOLATE
RUN TIME IS SHORT
BATTERIES ARE LOW ON WATER (LEAD ACID ONLY) SERVICE BATTERIES
CHARGER IS NOT SET PROPERLY FOR BATTERY TYPE SET CHARGER TO BATTERY SPECIFICATIONS
SCRUB HEAD IS IN HEAVY DOWN PRESSURE REDUCE SCRUB HEAD PRESSURE
BATTERY CHARGER IS NOT ABLE TO FINISH CHARGE CYCLE CONFIRM A STEADY GREEN LED AFTER THE CHARGE CYCLE
BATTERIES ARE DEFECTIVE OR AT THE END OF THEIR LIFE CONTACT SERVICE TECHNICIAN TO TROUBLESHOOT AND ISOLATE
SQUEEGEE IS NOT LIFTING OR
LOWERING
LIFT LINKAGE IS BOUND UP LUBRICATE OR LOOSEN HORIZONTAL HARDWARE
LIFT ACTUATOR IS DAMAGED VERIFY OPERATION AND REPLACE IF NECESSARY
WIRING IS DAMAGED INSPECT AND REPAIR
TROUBLESHOOTING GUIDE