Pacific energy SUPER 27 SPECTRUM, Руководство по эксплуатации

Страница: 11 / 20

230514-20 SUPER-SD1 11
Combustion Air
Intake or combustion air can be supplied to the stove
in one of two ways. Consult your local building code or
Installation Code for Solid-Fuel-Burning Appliances and
Equipment before proceeding.
1. Outside air supply - (Necessary for mobile home
installation, optional for residential installation.) Out-
side air may be drawn from either underneath the
stove or from behind.
To draw outside air through the fl oor, leave the
100mmknockout or cover plate in place in the rear
of the pedestal or leg kit ash box enclosure.
Pedestal Model: Cut or drill a 100mm diameter hole
in the fl oor anywhere inside the perimeter of the ped-
estal. Cover the hole with a 100mm x 100mm rodent
screen and staple/nail in place.
Leg Model: Cut or drill a 100mm diameter hole di-
rectly below the bottom hole of the ash box enclosure.
Connect enclosure to the fl oor with a short 100mmdi-
ameter pipe. If you wish to connect the outside air to
the rear hole on the ash box, then remove the 100mm
knockout or cover plate at the rear of the ash box.
This hole must get its air from a ventilated crawl
space or be extended with duct to the outdoors (see
Figure #4). The use of outside combustion air for
residential installation requires the unit to be secured
to the structure to prevent dislodging of the air duct.
To draw outside air from behind the stove cut or drill
a 100mm hole through a wall behind the unit. Use an
appropriate household 100mm inlet. You must remove
the rear cover plate from the pedestal or move the
cover plate at the rear of the leg kit ash box enclosure
to cover the bottom hole.
Note: This unit is not designed to be operated with the
fi ring door open. In addition to the obvious hazard of
sparks landing on combustibles, an open fi re door
will cause the heater to draw air from the living space
and possibly cause suffocation.
2. Room air supply - Remove the cover plate from the
rear of the pedestal or leg kit ash box enclosure. The
stove will now draw its air from the room through this
opening and into the fi rebox intake.
Note: The living space around the heater must be well
ventilated with good air circulation. Anything that may
cause a negative pressure can cause gases or fumes
to be pulled into the living area. During extremely cold
weather, and especially when burning at very slow
rates, the upper parts of the exposed chimney may
ice up, partially blocking the fl ue gases. If blockage
occurs, fl ue gases may enter living space.
* 100mm diameter air inlet with rodent screen
* If the crawl space is well ventilated it is not
necessary to extend air inlet to outside
HOODED VENT OR
90º ELBOW TURNED
DOWN
FIG. #4