100216-24
9
©PACIFIC ENERGY FIREPLACE
PRODUCTS LTD.
2) While supporting the side panel, remove the four screws
securing the front and rear pin brackets to the top face of
the Soapstone Side Panel. Fig. #3
3) Carefully lift the Soapstone Side Panel to disengage the
panel away from the unit. Fig. #4
4) Repeat steps 2 and 3 to remove the panel on the ooposite
side.
5) Reverse all steps to install Soapstone Side Panels and
Top.
FIG. #3
PIN BRACKETS
Table top leveling adjustment
:
pins from the hole in the bottom of the panel and pull the
FIG. #4
FIG. #3A
PINS
There are level adjustment bolts located underneath the
table top on both the left front and right front side of the stove.
If the table top rocks once installed, the table top needs to be
leveled.
To adjust:
1) Ensure that the bolts on both sides are in their down position
and are not making contact with the table top.
2) Raise either one of the adjustment bolts until it makes
contact with the bottom of the table top. Use a 1/2" open
end wrench or lift the table top high enough to fit your
fingers in and turn the bolt.
3) Raise the bolt on the opposite side using the same method
until the bolt on that side is also making contact. Check to
determine if the table top is still able to rock. Repeat adjust-
as needed.
Adjustment
bolts
FIG. #3B
