FUSION_D1 081112-20 7
Procedure:
CAUTION: THE STRUCTURAL INTEGRITY OF THE MO-
BILE HOME FLOOR, WALL AND CEILING/ROOF MUST BE
MAINTAINED.
Note: See "Combustion Air" section on page 9.
1.
Position stove and fl oor protection with hole for combustion
air in accordance with the clearances as stated on the label
and in Figure #2.
2. Mark the position for the hole in the ceiling and roof by
using a string and plumb-bob.
3. Check that the intended location will not interfere with fl oor
joists, ceiling joists or rafters before proceeding further.
4. Cut a hole in the ceiling and roof to suit the chimney system
and frame in the sides. The chimney support is mounted to
the framing.
5. Assemble chimney sections so the fi nished length is resting
on the support and protruding through the roof. Avoid having
joints between ceiling and roof. Install radiation shield.
Assemble fl ashing and storm collar and be sure to maintain
the vapour barrier at this point. (Seal securely.) Attach rain
cap and check fl ashing for leaks.
6. Install connector as per manufacturer's instructions.
7. Attach stove to fl ooring using two 1/4" x 2" or longer lag
screws.
Mobile Home
Installation
Warning:
Under no circumstances is this heater to be installed
in a makeshift or "temporary" manner. It may be fi red only after
the following conditions have been met.
-
DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE
SERVING ANOTHER APPLIANCE.
-
DO NOT INSTALL IN A SLEEPING ROOM.
- Outside air supply must be used for Mobile Home installations
see Figure #3, Page 7.
- The services of a competent or certifi ed installer, (certifi ed
by the Wood Energy Technical Training program (WETT) - in
Canada, Hearth Education Foundation (HEARTH) - in U.S.A.)
are strongly recommended.
Clearances
This heater must be installed with listed double-wall connector
and compatible chimney system listed on page 7.
Clearances to combustible surfaces and materials are shown
in Figure #2, page 5 and Figure #3, page 7.
Clearances may be reduced with various heat insulating materi-
als. Consult local fi re codes and authorities for approval.
NOTE:
Longer chimney lengths and different pitch fl ashings
may be used. All other parts listed must be installed (see Figure
#3, Page 7). Install all components to the connector or chimney
manufacturer's installation requirements. Consult your chimney
supplier for installation advice.
Содержание Fusion
Страница 17: ...FUSION_D1 081112 20 17 ...
Страница 18: ...18 FUSION_D1 081112 20 ...