-32-
2. Check that the wall outlet has power to it. The outlet may be on a switch and will not
function if not switched on.
3. If all connections are properly made and the unit is connected to a working outlet, check
the fuse in the charger (see Fuse section).
If these steps fail to produce satisfactory results, please refer to an authorized service
center to have the system fully analyzed.
How to Use This Charger:
With the scooter
completely assembled:
1. Connect the AC power cord to the receptacle
located on the scooter tiller (See FIGURE 10),
and then to a properly grounded AC outlet (See
FIGURE 11). (refer to grounding instructions)
As a safety feature, the scooter will not operate
when the charger cord is plugged into the wall
outlet and the charger is operating.
!! CAUTION !!
:
Do not use connectors or
cords that are cracked, corroded or do not
make adequate electrical contact. Overheat-
ing and possible property damage may result
if defective connectors are used.
2. The LED's located on the scooter charger will
indicate that the charger is giving service to the
batteries. When fully charged, the Orange LED
will turn to green
Because this is an automatic charger, the unit
will have a constant charge rate when all is
properly connected. This will continue at a steady rate until the batteries are approximately
90% charged, at which time the charger output will drop to less than 1 ampere. The charger
will occasionally "wake up" when battery decay has fallen to below the cut-off voltage, and
the charger will provide additional charge to "top off" the batteries.
3. After charging, remove the wall cord, fi rst from the wall, then from the cart, and store it
on the cart for future use.
FIGURE 10
FIGURE 11
