Page
63
of
67
Instructions for using the Board Supports
When performing rework on larger PCBs, the use of board supports
may be required to keep the PCB level at all times. PACE supplies a
set of board supports as optional equipment with the TF 2000. The set
consists of 6 cast iron support bars. The two longest bars are
positioned across the slide shafts on either side of the sliding shaft
holder. The remaining four attach quickly to both sides of the board
holder and rest on the bars positioned across the slide shafts providing
a level surface for PCB placement. The following procedure details the
proper usage for the board supports. (See Figure 26)
1) Install retaining screws at both ends of the bars to be positioned
across the slide shafts. (2 longest bars)
2) Place supports across the slide shafts, one on each side of the
sliding shaft holder.
3) Install an appropriate board support screw on the end of one of
the remaining board supports.
4) Place a thumbscrew in one of the four holes on one side of the
board holder.
5) Place a slide clip on the bottom of the board support and
position under the board holder, directly beneath the
thumbscrew.
6) Tighten thumbscrew just enough to hold the board support in
place.
7) Position the board support in the desired location and tighten
the thumbscrew for the associated board support. Repeat steps
3-7 for the remaining board supports.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Содержание TF 2000
Страница 33: ...Page 32 of 67 Artisan Technology Group Quality Instrumentation Guaranteed 888 88 SOURCE www artisantg com...
Страница 37: ...Page 36 of 67 Artisan Technology Group Quality Instrumentation Guaranteed 888 88 SOURCE www artisantg com...
Страница 63: ...Page 62 of 67 Artisan Technology Group Quality Instrumentation Guaranteed 888 88 SOURCE www artisantg com...
