8
G. Installing PCB
1. Loosen both
(A)
knobs to allow the PCB holders to glide freely in the X-
axis, and set the distance between them so that the spring loaded PCB
holder will hold the PCB firmly. Tighten the
(A)
knob on the left first, and
then slide the spring-loaded PCB holder into position and tighten the
(A)
knob on the right.
2. Pull back on the spring-loaded board holder and insert the PCB.
3. Once the PCB is in place, loosening knob
(C)
will allow the entire PCB to
glide freely in the X-axis using the fine adjustment job
(D)
. The PCB will
also slide freely in the Y-axis. Tighten knob
(C)
to lock the PCB in place.
NOTE:
If profiling a PCB/Component and when using thermocouple(s), attach
the thermocouple(s) to the desired position on the PCB and plug them into the
Sensor 1 or 2 positions as shown below,
before
inserting PCB into PCB holder.
B
B
A
C
D
A (Spring Loaded)
Thermocouple Inputs
