9
H. Preparation for Component Rework
1. The reflow nozzle to PCB standoff height can be established prior to
component placement. Pull the Reflow Nozzle Control Handle out from the
housing and slide the Reflow Assembly down to the PCB as shown below.
2. Fine placement of the reflow nozzle down to the PCB can be achieved by
setting the Nozzle to PCB Offset Limiter and twisting the nozzle control
handle in either direction as shown below.
3. The Reflow Nozzle can now be lowered gently to the PCB by twisting the
Reflow Nozzle Control Handle back to the lowered position.
Reflow
Nozzle
Control
Handle
Start
Finish
With the handle twisted so the
mechanics look like this…
…the Reflow Nozzle will float
slightly off the PCB.
Nozzle to
PCB Offset
Limiter
