6
Operation Manual
E. TF 1000 Setup
1. Place the TF 1000 on a flat and stable work surface.
2. Install the PCB Holder assembly by inserting the rear rail of the PCB
holder into the rolling guides on the TF 1000 housing and installing and
tightening the four screws shown in the figure below.
3. Insert the Microscope Optics into the Optics Holding Bracket and tighten
the Allen Screw after centering the Optics as shown below.
4. Connect the power cord to the AC power receptacle on the rear panel of
the TF 1000 and to the proper AC power source.
4 screws
Rolling Guides
Optics Holding
Bracket
Allen Screw
