©2018 PACE Inc., Vass, North Carolina, All Rights Reserved Page 3
System Set-Up
Set up the AccuDrive® system using the following steps.
1. Store the shipping container in a convenient location. Reuse of these
containers will prevent damage if you store or ship your system.
2. Place the Power Switch in the “OFF” or “0” position.
Handpiece Connection
The ADS200 is designed to work with the AccuDrive® TD-200 Tip-Heater Cartridge Iron and the AccuDrive®
specific Blue Series Tip-Heater Cartridges, which have a blue end-cap.
Caution:
Using other handpieces or Tip-
Heater Cartridges may result in damage to your ADS200 system or the attached handpieces and accessories.
Connect the handpiece connector to the Power Receptacle in the following manner.
1. Align guide on connector with slot on power receptacle.
2. Insert connector into power receptacle.
3. Turn the connector housing clockwise to lock in place.
Instant SetBack Tool Stand Connection
If your system includes the Instant SetBack Tool Stand (ISB Tool Stand), follow the steps below.
1. Connect cable from tool stand to receptacle located on the rear
panel of the ADS200 power supply.
2. Position the tool stand on workbench within operator reach.
3. Insert TD-200 with Tip-Heater Cartridge into the tool stand.
4. Turn ADS200 power switch to the on position.
5. When the TD-200 handpiece is inserted into the Instant
SetBack tool stand the ADS200 will activate Temperature
Setback Mode after a delay of 15 to 240 seconds (set from
factory for 30 seconds.) When the handpiece is removed from
the tool stand, the system will resume normal operation.
