Pace Technologies MEGA-T300A, Инструкция по эксплуатации

Страница: 22 / 61

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
MEGA - T300A
Abrasive Cutter
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 - 520 - 882 - 6598 Fax +1 - 520 - 882 - 6599 email: pace@metallographic.com Web: https://www.metallographic.com
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
Set SPEED
1. Move table to the front of the machine to
install the appropriate blade
2. Properly fixture the specimen with the
vises
3. Set the TABLE CONTROL switch to
MANUAL
4. If cutting with the table feed, lower the
cutter blade and lock into position. If
manual cutting with the wheel, advance
the table so the blade can advance all the
way through the sample.
5. Set the cutting parameters on the SCREEN
- CUTTING SPEED (rpm)
- OVERLAOD Amps for controlling cutting
force
6. Select the proper pump setting for the
coolant
7. Close the hood
8. Press the GREEN Start Button
9. Either feed the table or cutting wheel into
the specimen
10. If the OVERLOAD RED LIGHT flashes,
reduce the cutting force
11. After completing the cut press the RED
Stop Button
12. Allow blade and magnetic lock out to stop
and disengage, respectively and then
open the hood
13. Clean the cutting chamber and leave the
hood open when not in use
4.3.2 Manual feed cutting
17
Set TABLE
CONTROL to
MANUAL
Turn PUMP
to Auto or
On position
Turn
ON
LIGHT
START
STOP
Set OVERLOAD
for controlling
cutting force