Pace Technologies MEGA-T300A, Инструкция по эксплуатации

Страница: 12 / 61

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
MEGA - T300A
Abrasive Cutter
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 - 520 - 882 - 6598 Fax +1 - 520 - 882 - 6599 email: pace@metallographic.com Web: https://www.metallographic.com
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
!
Install unit carefully! Improper installation may void warranty.
!
The MEGA - T300A should be placed on a flat stable surface.
Connect coolant tank
supply, drain and
electrical connections.
! Electrical connections—The standard saw is designed to operate at 208 - 220V 3 - phase
(120V - 120V - 120V - ground) (optional 380V). Warning: if not connected properly to 3 - phase
power damage may occur to the motor and void the warranty.
Verify voltage on nameplate
! Verify the direction of rotation of the cut - off wheel. The wheel should turn from top to bottom
as viewed from the front of the machine. If not reverse any two of the 3 - phase power wires.
2.3 Installation
Main Power switch
(Installation continued on next page)
7
Inlet Coolant
Pump
Electrical
Drain Hose
Main
Power
Rinse
Supply