Pace Technologies MEGA-T300A, Инструкция по эксплуатации

Страница: 17 / 61

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
MEGA - T300A
Abrasive Cutter
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 - 520 - 882 - 6598 Fax +1 - 520 - 882 - 6599 email: pace@metallographic.com Web: https://www.metallographic.com
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
4.0 Start - up and Operation
4.1 General
The MEGA - T300A is a manual wheel and automatic / manual table feed cutter .
12
4.2 Control Panel
Coolant Pump
ON/AUTO/OFF
Cutting wheel ON/: Starts the cutting procedure.
Cutting wheel OFF/: Stops the cutting wheel (inductive brake engages to slow
wheel). Hood cannot be opened until safety lock releases in
approximately ~2 - 8 seconds after pressing the stop button.
Coolant ON/AUTO/OFF: Operates the coolant pump in Auto or Manual mode. Must
be selected before starting the motor.
Light ON/OFF: Turns inside chamber light On or Off.
Selector / adjuster
knob
Rotate to select feature, push to accept
TABLE CONTROL: Select Auto for automated table cutting and Manual for
manual table feed cutting
Joystick: Controls the position of the table, X - Y axis
Cutting
wheel (ON)
Light
ON/OFF
Cutting
wheel (OFF)
Selector /
adjuster
knob
Information
Screen
Table Control
(Auto/Manual)
Joystick for table
positioning control