PEC017
5/3/2018
Page
89
of
105
All Manual HC Desorb and Auto HC Desorb notifications refer to HC Desorb as a
“Regeneration” or “Regen”.
If PTO is active, Auto HC Desorbs may occur but will not change engine speed.
Engine speed needs to be greater than 900 rpm for Auto HC Desorbs to be enabled
with PTO active.
HC Desorb differs from DPF Regenerations in that there is no additional fuel dosing
during an HC Desorb. As a result, tailpipe temperatures will remain below 500 °F (260
°C).
Desorb Notifications on the Driver Display
Figure 20.1 shows an example of the notification displayed while an Auto HC Desorb
is in progress. This applies to both Peterbilt and Kenworth on non-VECU, NAMUX 2 &
3 trucks.
Figure 20.1
– NAMUX 2 & 3 Auto HC Desorb Occuring Notification; Left: Kenworth, Right: Peterbilt
Figure 20.2 shows an example of the countdown timer notification before an Auto HC
Desorb is started, counting down from 120 seconds. The Auto Desorb will start when
the timer reaches 0 seconds. This applies to both Peterbilt and Kenworth on non-
VECU, NAMUX 2 & 3 trucks.
Figure 20.2
– NAMUX 2 & 3 Auto HC Desorb Pending Notification; Left: Kenworth, Right: Peterbilt
Содержание MX Series
Страница 1: ...PEC017 5 3 2018 Programming Guide EPA 2017 ...
Страница 9: ...PEC017 5 3 2018 Page 9 of 105 Graph 4 2 MX 13 Power and Torque Curves for Multi Torque Ratings ...
Страница 11: ...PEC017 5 3 2018 Page 11 of 105 Graph 4 4 MX 11 Power and Torque Curves for Multi Torque Ratings ...
Страница 43: ...PEC017 5 3 2018 Page 43 of 105 Graph 11 2 MX 11 Engine Brake Performance Curves ...
