Paccar Braden PD12C, Инструкция по установке, обслуживанию и ремонту

Страница: 9 / 40

9
ANCHORING WIRE ROPE
RECOMMENDED FASTENER TORQUE
Higher or lower torques for special applications will be speci fi ed such as the use of spanner nuts, nuts on sha ft ends, jam nuts
and where distortion of parts or gaskets is critical.
Lubricated torque values based on use of SAE 30wt engine oil applied to threads and face of bolt or nut.
Avoid using thread lubricants (such as anti-seize compound) as the applied torque may vary by 10 - 40%, depending upon the
product used.
5(&200(1'(')$67(1(572548(
7RUTXH/%)71P 7RUTXH/%)71P
%ROW
'LDP
,QFKHV
7KUHDG
SHU
LQFK
*UDGH *UDGH
%ROW
'LDP
,QFKHV
7KUHDG
SHU
LQFK
*UDGH *UDGH
'U\ /XEHG 'U\ /XEHG 'U\ /XEHG 'U\ /XEHG
7RFRQYHUW/%)7WR.JPPXOWLSO\/%)7YDOXHE\
WIRE AND BRAIDED ROPE INSTALLATION
Take the free end of the wire rope and insert it through the
small opening of the anchor pocket. Loop the wire rope and
push the free end about half of the way back through the
pocket. Install the wedge, then pull the slack out of the wire
rope. Th e wedge will slip into the pocket and secure the wire
rope into the drum. Th e early style anchor wedge is designed
to accommodate several di ff erent sizes of wire rope. You may
anchor 7/16 and 1/2 in. (11 & 13 mm) wire rope by inserting
the wedge, large end fi rst. Anchor 9/16 and 5/8 in. (14 & 16
mm) wire rope by inserting the wedge, small end fi rst.
ANCHORING BRAIDED ROPE
Early Style
Wire Rope
Anchor
A special wedge is used to anchor 1 and 1 1/8 in. (25 & 28 m)
braided synthetic rope. Th e installation procedure is the same
as for anchoring wire rope.
CORRECT INSTALLATION
INCORRECT INSTALLATION
Figure 7 Figure 8 Figure 9 Figure 10
Drive from
this side
Wedge and wire
rope fully seated in
pocket
Wedge not
fully Seated
Wedge pulled
too far through
anchor pocket
Must keep at least 5 wraps of wire rope
on cable drum at all times.