Paccar Braden PD12C, Инструкция по установке, обслуживанию и ремонту

Страница: 20 / 40

20
OUTPUT PLANET CARRIER
DISASSEMBLY
1. Remove the planet gears by driving the roll pins into the
center of the planet sha ft s.
2. Use a punch to drive the roll pins from the planet sha ft s.
Do not reuse the roll pins.
3. Now you can remove the planet sha ft s, bearings, spacer,
thrust washers and gears. Th oroughly clean all parts and
inspect for damage and wear. Th e bearing rollers should
not exhibit any irregularities. If the rollers show any sign
of spalling, corrosion, discoloration, material displace-
ment or abnormal wear, the bearing should be replaced.
Likewise, the cage should be inspected for unusual wear
or deformation, particularly the cage bars. If there is any
damage that will impair the cage’s ability to separate, re-
tain and guide the rollers properly, the bearing should be
replaced. Th e thrust washer contact areas should be free
from any surface irregularities that may cause abrasions
or friction. Th e gears and sha ft s should be inspected for
abnormal wear or pitting. Replace if necessary.
ASSEMBLY
1. Place the output planet carrier on workbench with splined
coupling side down. Install output thrust plate in center of
carrier.
PLANET CARRIER SERVICE
PD17A hoists have an internal retaining ring to hold the
thrust plate into the carrier. Th is retaining ring MUST be
properly installed and fully seated before the planet gears
are installed.
CAUTION
!
!