Pacbrake PowerHalt PH2, Руководство по установке

Страница: 7 / 14

PowerHalt is a registered trademark of Pacbrake Co.
6
PH2 - AUTO / MANUAL / ELECTRIC WITH PULL CABLE(S)
L6372
L6372_REV6.17.04.2018
ECN 1-1859
MANUAL KIT INSTALLATION
9
SWITCH INSTALLATION
Locate the desired location for the activation switch in your cab
or control panel.
NOTE:
• Activation switch should be as close to driver’s side door as
possible to allow for shutdown when standing outside of the
vehicle
• Consider the dash construction, as the switch requires a single
dash wall for install unless the double wall is modified
• DO NOT ACTIVATE THE MANUAL SWITCH FOR
MORE THAN 10 SECONDS.
Damage to the solenoid may occur
10
Drill a ½" hole in the desired location.
11
Install the toggle switch through the backside of the dash and
then remove the nameplate cover film and install the nameplate,
toggle cover, and lock washer as shown in picture.
Tighten lock washer firmly.
NOTE: If the dash cannot accept the switch nameplate, use the
toggle sticker and install onto the switch cover as shown.
12
ELECTRICAL WIRING (MANUAL ACTIVATION)
Connect the relay, toggle switch, power source and valve
solenoid as per schematic on page 11.
9A
9B
9C