Single Channel Wireless Air Spring Controls
L6597
6
2 MARK & DRILL MOUNTING HOLES
Use the air compressor and controller as templates to mark the locations of the drilled holes.
Place each component in the desired location/orientation and mark the centers of each hole: 4 holes on the compressor,
2 holes on the controller.
PLEASE NOTE: The controller should be mounted with the connectors pointing downwards to prevent ingress of standing water.
Use a center punch to indent each drill mark and drill six 7/32” [5.5 mm] holes through the marked locations
Use caution when drilling to not damage any wiring, fuel lines or other vehicle components near or behind the drill
location.
3 MOUNT COMPRESSOR ASSEMBLY & CONTROLLER
Secure the air compressor assembly using four #10-32 x 1.25” socket
head screws, eight #10 flat washers and four #10-32 nylon lock nuts.
Secure the controller using two #10-32 x 1.5” socket head screws, four
#10 flat washers and two #10-32 nylon lock nuts.
Torque all mounting hardware to 7.9 N•m [70 in-lbs].
PLEASE NOTE: Ensure compressor assembly and controller do not
pinch or interfere with surrounding components when installed.
4 CONNECT WIRING HARNESS
Install the single channel wiring harness as per the included schematic (Figure 4 on the following page).
• Connect the 2-pin and 6-pin connectors on the harness to the matching connectors on the compressor assembly
• Connect the 12-pin harness connector to the indicated socket on the controller
Ensure all connectors are fully latched and secure.
Do NOT remove pins from connectors to pass through small sized holes.
Unnecessary connection and disconnection of harness connectors will wear out plating on electrical contacts and
negatively affect continuity
Step continues on following page...
3