P1PE P3000PWA, Руководство пользователя

Страница: 9 / 28

9
PRESSURE WASHER PREPARATION
ATTACHING FOOT ASSEMBLY (Fig. 1)
PARTS NEEDED: 1 foot, 1 M8 lock nuts.
1 . Raise or tilt pressure washer so you can line up the foot with
the hole located at the centre of the frame.
2 . Attach foot by inserting the bolt from the bottom up and install
the acorn nut. Tighten until there is a slight crush on the frame
tube. Do not over tighten.
Fig. 1
INSTALL HANDLE (Fig.2)
Fig. 2
Install upper frame (handle) on to the lower frame by
sliding the handle over the two upright tubes on the lower
frame and pressing down firmly until the handle is seated
and the two locking pins snap in place.
ATTACHING UPPER AND LOWER GUN HOOKS (Fig.3)
1 . Align the upper gun hook with the holes. Attach using the
included nuts and bolts.
2 . Attach the lower gun hook. .Make sure that the gun hook is
straight and correctly aligned before tightening. Tighten until
the nut is snug. Do not over tighten.
Fig. 3