P1PE P3000PWA, Руководство пользователя

Страница: 13 / 28

13
-
Fig. 11
Fig. 12
OPERATION
USING THE SPRAY GUN (Fig. 11 & 12)
Flip the lock tab behind the trigger up or down until it clicks to apply or remove the safety. Pull back on the
trigger to begin operating pressure washer. To stop water flow, release trigger.
STARTING PRESSURE WASHER (Fig. 13 & 14)
1 . Place pressure washer on a level surface. Turn on water.
2 .
Purge the system’s pump of air by releasing the safety and
squeezing the trigger of the spray gun. Attach wand/lance to spray
gun.
3
Slide the choke lever to the “Choke” position.
Turn the engine OFF/ON switch to the “ON” position.
4 Holding the machine with your hand, pull the recoil handle
(starter cord) slowly until resistance is felt, then pull rapidly.
5 Squeeze the gun trigger and release the pressure after every
failed attempt to start the pressure washer in order to reduce back
pressure.
6 Let the engine run for several seconds. Then gradually slide
the choke lever to the RUN position as the engine warms up
until the choke is fully slid to the RUN position.
Fig. 13
Fig. 14
WARNING: Pulling the pull cord of the recoil starter rapidly can pull your arm towards the engine faster
than you can let go which could result in injury. To avoid recoil, pull starter cord slowly until resistance is
felt, then pull rapidly.
STOPPING PRESSURE WASHER (Fig. 15)
1. Turn the ON/OFF switch to the OFF position.
2. Turn off water and squeeze the trigger handle to release
all water pressure.
Fig. 15